I/O Series FGR2-IOS & FGR2-IO 900 MHz Industrial Radio

The FGR2-IOS radio with embedded I/O functions is available in either as board level device or in an enclosure. The FGR2-IO-IOE has embedded I/O functions is available in Expandable I/O.

All models can operate in one of two modes: Modbus and Wire Replacement.

* In the Modbus mode, all models can be directly connected as an I/O peripheral to a SCADA network.

* For Wire Replacement mode (wireless signal replication), the all models can operate as an Endpoint linked to an FGRIO-M (Gateway) radio.

The enclosure version also includes switchable and protected resistors for convenience when using 4-20 mA sensors.

* All AIs are reported as 16-bit integers or 32-bit floating points.

* Pulse counting (32-bit) DIs allow detection of 500 used. Pulses and count to 1000 Hz.

* Active data port allows extension by adding external devices.

* Single register access to 16-bit a/d. Two register access for full 20bits.

* Enhance proportional control by 4 to 20 mA AOs with programmable off sets and commloss set points.

* DOs control up to 60 W each and have optional pulse-output protection intermittent rated loads.

These products are also expandable with the IOE-4422 I/O Series.

The FGR2-IOS is UL Class 1, Division 2 approved.

All radios are designed, manufactured and tested in Boulder, CO.

KEY FEATURES

User-configurable: I/O Digital or Analog Long Range: 60 miles with clear line of sight with the ability to extend through Endpoint/Repeater. Modbus Gateway can be any FGR Series radio.

Noise Immunity: Superior performance in noise congested environments.

Error Free Communications: 32-bit CRC with automatic retransmissions.

Low Power Consumption: Ideal for solar, battery, and DC applications.

Industrial Grade: Operating Temperature from -40°C to +75°C.